LS Swap guide

M20/M30/M50/Whatever! All engine related stuff here.
User avatar
Yoshi
Site Admin
Posts: 9093
Joined: Thu Feb 26, 2009 7:47 pm
AntiSpam: No
Location: North VA
Contact:

LS Swap guide

Postby Yoshi » Fri Nov 15, 2013 7:44 pm

***This is a WIP. I'll be updating as I get more information***

LS E30 Swap Guide

Intro - This guide is for the very basics of swapping an LS into an E30. The tutorial assumes a T56 transmission and a naturally aspirated final install. This tutorial also does not go into choosing an LS engine.

Chassis modifications

Minor drive tunnel “clearancing” (read: hammering) required. (TBD - pictures)

Mounting

Sikky has a mount kit that includes mounts and an oil pan used to physically mount the engine in the car without contact. (TBD - other mount kits)

Driveline

Sikky supplies a telescoping single piece driveshaft. This type of driveshaft enables removal without lowering/removing the rear subframe. (TBD - other mount kits)

The factory T56 shifter will line up with the factory E30 shifter hole.

Clutch connections

A master cylinder conversion is required. The stock master cylinder may be retained.

TBD

Steering


  • Power steering - Minimum fabricating new lines. Assistance may be weak. Upgrade TBD
  • If using the Sikky swap kit, a flex disc removal modification is required to clear the headers. TBD (find other options)
  • E36 rack required to clear headers

Brake System

By default the brake booster will contact the driver’s side head. Sikky has a boosterless setup or a hydroboost conversion that taps into the factory power steering.

Cooling

The factory LS block has cooling system inlets and outlets on the passenger’s side of the motor. As a result, the factory E30 radiator will not work. A suggested upgrade is a larger radiator allotted by the shorter engine. Depending on the LS motor, there may still be clearance issues.

Fuel system

The LS engine is a returnless system. There are several options to convert. Some GM fuel filters come with the fuel pressure regulator built in. Another option is to buy a special fuel pressure regulator used to convert to a returnless system.

An upgraded fuel pump is also required (walbro 255/aeromotive/etc)

Intake

New intake piping will have to be fabricated. There are currently no off the shelf solutions.

Wiring

TBD
Image
Status: HG repair. 488wtq though!

Return to “Engine”

Who is online

Users browsing this forum: No registered users and 3 guests